Press Break
Job ID: 566106
Location: Gahanna, OH
Category: Manufacturing and General
Employment Type: Temp to Hire
Temp to Perm Position: conversion to FT upon meeting job duties and hourly requirements.
Second Shift Hours: Mon – Thursday 3:15 p.m. – 1:45 a.m.
Initial training could take place on:
^ FIRST SHIFT: Mon – Fri 7 a.m. – 3:30 p.m. and/ or
^ SPLIT SHIFT Mon – Thursday 10 a.m. – 8:30 p.m.
- Supports various departments on shop floor including but not limited to: Fabrication, Hardware insertion, Assembly, etc.
- OTJ + cross training provided
- Will train and work in tandem with experienced and seasoned associates already on staff.
Required Skill set for Brake Operators/Fabricators:
^ Ability to perform own set ups and operate our 85 – 175 ton CNC + ATC Amada + Toyokoki Brakes (cannot be merely operators)
^ Top notch print reading and interpretation skills.
^Ability to work within tolerances of + .005 and ½ degree.
^ Able to accurately measure and record results of part dimensions + characteristics using calipers and mics.
^ Ability to adjust offsets.
^ Demonstrated detail orientation.
^ Work well independently and on a team in Job Shop environment.
^ Ability to follow and retain instructions.
^ Familiarity with ISO procedures /quality standards is beneficial.
^ Physical ability to stand, squat, bend, reach, pull and push during course of a 10 hour shift.
^ Ability to lift up to 50 lbs. with regularity. (average parts run 2-15 lbs)
Required General Fabrication skills:
^ Ability to learn Hardware insertion tasks.
^ Operate Finishing equipment such as a Fladder, Hand grinders, deburring equipment, etc.
^ 2-3 yrs. knowledge + experience in mechanical assembly within a manufacturing environment helpful
^ Mechanically inclined: able to use a variety of power/air and hand tools including rivet gun.
^ High attention to detail & fine tactical ability.
^ Pallet jack experience
